Ushio JCD240V-500WC - 1000914

Features

• Ushio JCD240V500WC Halogen Bulb
• Single Ended Lamp
• Use Only in Approved Enclosed Halogen Fixtures

• DANGER! The Ushio JCD240V-500WC replacement lamp operates at extremely high temperatures that can cause serious physical injuries and property damage.
• Only use the Ushio JCD240V-500WC replacement lamp in Halogen-approved fixtures. Fixtures should fully contain any parts of the Halogen lamp upon the event of a lamp burst.
• Do not use the JCD240V-500WC Ushio replacement lamp in close proximity of paper, cloth or other combustible materials that can cause a fire hazard.
• Lamps are very fragile. Do not drop, crush, bend or shake them. Vibration or impact will cause filament breakage and short lamp life.
• Do not touch the Ushio JCD240V-500WC bulb surface or inside reflectors with your bare hands. Oils from skin can lead to breakage or shorten the life of the lamp. Use clean gloves or lint-free cloth for installation and removal.
• Clean any dirt, oil, or lint away from the bulb with alcohol and a lint-free cloth or tissue. Any foreign particles or materials on the JCD240V-500WC Ushio replacement bulb surface can cause hot spots on the bulb and result in lamp failure.
• Never touch the Ushio JCD240V-500WC lamp when it is on, or soon after it has been turned off, as it is hot and may cause serious burns.
• Do not look directly at the operating bulb for any period of time; this may cause serious eye injury.
• Always turn off the electrical power before inserting, removing, or cleaning the replacement Ushio JCD240V-500WC lamp.
• Affix the JCD240V-500WC Ushio replacement lamp securely in the socket. Improper installation of the Ushio JCD240V-500WC replacement lamp will cause electrical arcing, overheating and short life to lamp and socket. Replace lamp holders and sockets when necessary.
• Keep the temperature of the Ushio JCD240V-500WC lamp seal below 350C.
• Keep the temperature of the JCD240V-500WC Ushio replacement lamp wall above 250C.
• Keep the temperature of the Ushio JCD240V-500WC lamp wall below 800C.
• Make sure lamps of specified wattage and voltage are only used in appropriately rated fixtures. Unspecified use will lead to short lamp life, breakage and overheating of fixture.
• Ushio JCD240V-500WC replacement lamps should not be operated beyond the total rated voltage. Avoid the use of dimmers that may drive your lamp over its rated voltage.
• Operate the Ushio JCD240V-500WC replacement lamp only in the indicated burn position. Failure to do so will lead to overheating and shortened lamp life.
• Use an external fuse when required.
• Do not allow one lamp to directly expose another. This may lead to overheating and shortened lamp life.